Material you will need:

• A billycan,
• A piece of large string,
• Scissors

Making the cover:

1° Pull the string through the handle of the billycan.

2° Put the two bits at the same length on the handle

3° Pull bit #1 around bit #2 (picture A).

4° Pull bit #2 under the handle and bit #1 over the handle. Tighten both bits. (picure B).

5° Pull bit #1 around bit #2 without letting go off the string so as not to losen the knot.
Bit #1 is still over the handle and bit #2 under the handle. (picture C)

6° Keep on with the same procedure until you’ve covered up the handle entirely. Finish with a square knot.